Posts tagged as:

Spin


Note: Using the stove element with very little surface contact the max operating psi is 25-30psi. With propane the surface area of heating will increase and allow higher working pressure and a dryer steam. I have a VW jetta alternator (3-4 times larger than turbine!) to mount next for 12-14volt output test by request. . Last I checked in Nov. the steam from my 5 gallon boiler worked well but this tested to 250psi welded tank is much more portable and will be good for fresnel or propane fuel. I do not recomend anyone without years of welding experience choose any compressed air tank to use as the inside could be rusted and cause rupture of seams. britgaskets.ca . DO NOT ATTEMPT THIS!! PRESSURIZING AN UNTESTED AIR TANK CAN CAUSE EXPLOSIONS, DAMAGE TO THE HOSES, BURNS, FIRE, LOSS OF LIFE, AND LOSS OF PROPERTY!! THEY MUST BE ABLE TO TAKE HEAT AND 2-3x PRESSURES REQUIRED. IT MAY ALSO BE ILLEGAL IN YOUR AREA. DON’T EVEN THINK IT!! . 100psi and under is considered “hobby” and I sure trust the tig welds more than say a silver soldered copper boiler. 2 relief valves 1 at 90psi and one at 150psi just to be safe. The turbine once spun up is sustained at 30-40psi and the torque by guesstimate is 2x or 3x that of compressed air. A very shocking increase when I first tried to slow the shaft.

{ 3 comments }

Spin Dryer Run

January 22, 2011

One of my first runs with our new 3000 RMP centrifugal dryer. Run your clothes through this before the regular dryer to remove most of the water and lower the time and energy used to dry clothes. Enjoyed this article?More information on Go Green Tips!

Read the full article →

A New Spin On Affirmations For Weight Loss And Natural …

December 5, 2009

http://www.renegadehealth.com – It’s “Funday” Monday on the Renegade Health Show and I think you’ll enjoy what I have in store… I was invited to a late-night closed doors presentation by Noah St… Enjoyed this article?More information on Go Green Tips!

Read the full article →
</